A trio of QRPGuys kits

A while ago (back in October) I ordered a few kits from QRPGuys: a dummy load, mini-paddle, mini keyer and two digital frequency counters (PTH and SMD versions).

I finally got around to assembling the dummy load, paddle and keyer over the past week.

QRPGuys kits
Iambic paddle, mini-keyer and dummy load from QRPGuys

The dummy load was the easiest to assemble, and parts placement was pretty obvious (I’m only a little bit bothered because the resistors don’t line up…). 5 minutes of soldering and you’ve got yourself a nice compact little 12 watt dummy load that also lets you measure power output via a voltage measurement.

The mini-paddle was only a little more difficult because of the size and length of the screws being used to attach the paddles. Still a relatively easy build, although you have to be careful with the alignment of the little PCB pieces that are soldered onto the base. The hardest part was getting the little nuts that hold the paddles secured. There’s not a whole lot of space to work in, you have to hold the screw, spacers, washers and metal paddle part while trying to get the nut on, and there’s not a whole lot of screw remaining to get the nut started on. Moderately difficult to assemble.

In terms of parts count, the single lever keyer/paddle was the largest kit, but easier to assemble than the iambic mini-paddle. On the electronics side, the only thing I had to consult the assembly manual for was to find out the correct orientation for the 1N4148 diodes. Placement of all the other parts is pretty obvious from the silkscreen outlines. On the keyer side, assembly was similar to the mini-paddle, but with only one lever to worry about, getting it put together was significantly easier. I did end up leaving off two nuts for the two screws that serve as contacts for the paddle. With the nuts, the screws were just too far away from the paddle. I don’t know if the screws I got were just too short to begin with, or if the kitting changed but the instructions didn’t get updated.

True to their mission, these are fun, inexpensive little kits to put together. Looking forward to working on the frequency counters next.