SA602 and SA604 to play with

Last week, Dave/AA7EE announced that he had a bunch of SA602s and SA604s to give away. I emailed Dave to ask for some, and he sent me 18 602s and 6 604s. Thanks Dave!

These are surface mount ICs, so I ordered up some SOIC-8 and SOIC-16 breakout boards from Adafruit.

The package from Dave arrived earlier this week, and the breakout boards arrived in the mail today.

SA602 SMDs
SA602 SMDs
SA604 SMDs
SA604 SMDs

The breakout boards came bubble-shrink wrapped which was a little unexpected. I thought they’d just come loose in a ziplock bag or something.

Adafruit SMD breakout boards
Adafruit SMD breakout boards

The boards are double sided, with SOIC-8/16 spacing on one side and TSSOP-8/16 spacing on the other side.

Adafruit SOIC/TSSOP 8 breakout boards
Adafruit SOIC/TSSOP 8 breakout boards
Adafruit SOIC/TSSOP 16 breakout boards
Adafruit SOIC/TSSOP 16 breakout boards

Interestingly enough, the SOIC-8 boards are half the thickness of the SOIC-16 boards, which are a regular thickness circuit board. Both have sets of holes (standard 0.1″ spacing) to solder header pins to, making them convenient to use in breadboard projects. Or you could just solder wires to them if that’s what the project calls for.

Off to the workbench to do some soldering. For SMD parts, these are actually pretty large, and soldering is relatively easy. First, tin one of the pads and then with tweezers, line up the IC and then heat up the tinned pad. Use the soldering iron to push the solder towards the IC pin and you’re done.

Soldering an SA602 to the breakout board
Soldering an SA602 to the breakout board

I used a toothpick to apply a little bit of flux paste to the rest of the pads, and then soldered the rest of the pins. That part goes pretty easily with flux.

Pro tip #1: Don’t do this with the board clamped in a vise, or if you do, don’t leave the soldering iron on the board for too long. These SOIC-8 breakout boards are pretty thin and too much heat will make them melty. Oops.

Melted breakout board. Ooops
Melted breakout board. Ooops

Once you’re done, it’s time to add some header pins. This part is easy. Stick the header pins into a breadboard, put the breakout board on the header pins and solder.

Adding header pins
Adding header pins

Pro tip #2: In your enthusiasm to solder, don’t forget to pay attention to where Pin 1 of the IC is supposed to go (ignore that bad solder job on Pin 2…easy to fix). That stripe on the SA602 should be where the 1 is printed on the board. Oops.

SA602 is upside down on the breakout board. Ooops
SA602 is upside down on the breakout board. Ooops