CC1 enclosure

My CC1 is finally in its enclosure!

CC1 enclosure
CC1 enclosure
CC1 enclosure
CC1 enclosure

The templates for the faceplates I made worked out pretty well. The holes weren’t perfect, but I blame that on using a drill to make the holes. Would have been much easier if I had a drill press, or ideally a hole punch. For the BNC hole, I didn’t have a 1/4″ drill bit so I just used a 3/8″ bit (the largest I had) and my Dremel with a sanding drum to enlarge the hole.

CC1 enclosure
CC1 enclosure
CC1 enclosure
CC1 enclosure

Looks pretty good in its enclosure I think. Now I need to put some labels on it.